|
|
FTI 45mm & 30mm extrusions were used to build this single-rack cabinet. Interior rack-rails were provided for both front & rear support of components. Access doors provided on the front & rear of the cabinet had locking latches for security. Clear polycarbonate panels were provided for equipment monitoring. |
||
 |
This cabinet was constructed using 45mm x 90mm, 45mm x 45mm & 30mm profiles. The left side of the cabinet had a light-tight area for sensor testing. The right side had a cpu storage area, pull out keyboard shelf with a monitor support shelf above. |
 |
|
 |
Heavy duty electronic & equipment rack was provided in a near fully assembled form. the customer would finish equipment installation & then install the pre-cut panels & trim the we provided. Leveling casters were provided to facilitate final positioning of this cabinet that would ultimately weigh in @ 1000lbs. |
|
